[. . . ] Enclosure Overview Switch Screw 1 Screw 2 Addonics TECHNOLOGIES Fan USIB Port Power Connector Zebra USIB SATA Drive Enclosure ZSAUSCSU & ZSAUSCSF Removing the front panel You can remove the front panel of the enclosure to access the drive drawer of the optical drive. User's Guide Step 1 Loosen the two screws from the rear panel. [. . . ] If the equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment on and off, the user is encouraged to try and correct the interference by one or more of the following suggestions. Reorient or relocate the receiving antenna Increase the distance between the equipment and the receiver Connect the equipment to a different power outlet other than the one where receiver is connected Consult a certified television or radio technician 15-pin SATA power cable 7-pin SATA data cable Screw holes Technical Support Step 3 Use the enclosed screws to secure the hard drive to the tray. If you need assistance to get your unit functioning properly, please call Addonics Technical Support. Our technical staff will be happy to assist you, but they will need your help to do so. Calling the technical support staff without all the proper information can be both time consuming and frustrating. Here are some tips to help you out: MODEL NUMBER ­ Please have this number on hand. OPERATING SYSTEM ­ What version of Windows WHAT'S THE TROUBLE?­ Give enough information about your problem so that we can recreate and diagnose it. [. . . ] Turn on the switch. Note: Windows 2000 & XP use built-in drivers. [. . . ]